CNC machined billet alloy clutch pressure plate with the essential "Needle roller lift" mechanism.
The billet pressure plate does not bend or flex like the original steel pressure plate which makes the clutch plates free off easier and bite better when clutch lever is released.
The needle roller lift mechanism fits in the end of the gearbox mainshaft and when the clutch lever is pulled in, the pressure plate lifts off the plates square and evenly, this means the clutch springs can be tensioned up less than usual, which gives a much lighter and positive clutch with better bite when the clutch lever is released.
This kit is complimented by the Multiplate kit, see part number MULTIPLATE-KIT
A light two finger lift clutch operation is easily obtained by using these parts, also removes the gear " crunch" when changing gear and neutral is easily selected when at a stop.
Fits all BSA and Triumph 4 spring clutches fitted to the following models
BSA A50 and A65, Triumph Unit T120, and Triumph pre-unit T100 T110 and T120
Clutch pushrod will require shortening, full instructions are included in the kit.
Note: please check condition of clutch basket and centre cush drive unit for wear and tear.
